Extra Wideband 10 MHz-4.2 GHz

The ViaLite Extra Wideband RF over fiber link has a 10 MHz-4.2 GHz bandwidth, suitable for C-Band downlink applications, linking satellite antennas to control rooms, network operation centers and broadcast headends.

  • 50 Ohm
  • Ultra-wide dynamic range
  • Transmits any RF signal – regardless of modulation scheme
  • Interfaces with monitor and control (M&C) systems for remote monitoring
  • 5-year warranty as standard

 

Product Inquiry
Extra Wideband 10 MHz-4.2 GHz

Ultra-wide dynamic range

One of the link’s key features is its ultra-wide dynamic range. This allows wider bandwidths to be transmitted including the entire 700-2450 MHz.  For High Throughput Satellites (HTS), the bandwidths are 500, 800 or 1500 MHz.

Manned from a control room

ViaLiteHD links can be controlled remotely using SNMP or Ethernet, as well as other Ethernet-controlled equipment such as the antenna, converters or amplifiers.  This allows multiple antennas to be controlled over fiber from a control room.

Further features and benefits:

  • Reduced spares.

In satcom, the 10 MHz-4.2 GHz bandwidth is compatible with both 70/140 IF and L-Band HTS signals – minimizing spares requirement.

Other link options include the ViaLite Ultra Wideband link at 2 kHz – 4.2 GHz and the ViaLite Wideband link.

The Extra Wideband link is available in several formats:

– Single rack chassis card / Dual rack chassis card (Rx/Rx, Tx/Tx or Tx/Rx)

A fully populated 19” 3U ViaLiteHD rack chassis supports up to 26 links and accepts 13 RF cards, plus a Monitoring & Control Module and dual power supply modules.  A 1U chassis accepts three RF cards or two RF cards with a Monitoring & Control Module.

– Blue OEM Link

The ViaLite standalone Blue OEM Link offers a compact, single link solution.

– Yellow OEM Link

The Yellow OEM Link has been designed for system integrators and equipment manufacturers to build the link into their own designs.

– Blue2 Link

The Blue2 Link is a dual-solution OEM which can be setup as 2x transmitters, 2x receivers or a transceiver, as required.

A range of support modules and accessories is also available, including indoor rack chassis units and weatherproof outdoor enclosures.

See our hardware formats guide for more information.

RF Performance Characteristics

Extra Wideband link
Frequency range10 – 4200MHz
Impedance50Ω (SMA connector)
Flatness± 1.0dB t a
VSWR (50 Ohm)≤ 2:1 t
Maximum input power+15dBm (without damage)
Gain stability±0.25dB over 24 hrs
RF link gain (nominal)0 dB a
Input IP314dBm t a
Input P1dB2dBm t a
Noise figure23dB t a b
SFDR110dB/Hz 2/3 t a b

a @ 0 dB optical loss
b Calculated at 1200MHz
t typical

 

Optical Performance Characteristics

Extra Wideband link
Laser typeDFB
Optical wavelength1310nm ± 20nm (1550nm/CWDM options)
Optical power output4.5dBm (nominal)

 

Temperature Characteristics

Extra Wideband link
Operating temperature-20 °C to +60 °C e
Storage temperature-40 °C to +70 °C

e Datasheet parameters based on temperature range -10 °C to +50 °C, refer to user manual for performance parameters at -20 °C to +60 °C.

 

Extra Wideband 10 MHz-4.2 GHz

HRT-W1-8R-05-S1310
Transmitter, Wideband 10 MHz-4.2 GHz, 50 Ohm SMA, Singlemode SC/APC, Rack plug-in module, Wavelength 1310 nm.

HRR-W1-8R-05
Receiver, Wideband 10 MHz-4.2 GHz, 50 Ohm SMA, Singlemode SC/APC, Rack plug-in module.

ViaLiteHD Extra Wideband Link Datasheet  (version HRx-Sx-DS-1)
Blue OEM Datasheet  (version HRx-xx-xM-DS-6)
Blue OEM Power Supply Datasheet  (version HPS-CB-xx-DS-1)
Blue2 Link Datasheet  (version HRx-xx-xP-5)
Yellow OEM Datasheet  (version HRx-xx-xN-DS-6)
ViaLiteHD RF Link Handbook  (version HRx-HB-9)

Share: Email this page: Print: Subscribe for news: